An independent reference about tanks, barrels and water storage at a country house. It does not sell equipment, gives no medical advice and is not connected with the former site on this domain.

Reference

Reference

Here are the conversions and formulas a tank or barrel owner needs. Only the unit definitions and the general properties of water are exact. All sizes in the examples are illustrative: replace them with your own measurements and recalculate.

A litre is a cube of water one decimetre on each side. Picture that cube, and you can mentally break any tank down into litres.

— Side note

Units of volume

Litre
Equal to 1 cubic decimetre, that is, the volume of a cube with sides of ten centimetres.
Cubic metre
Exactly 1000 litres. Multiply a tank volume in cubic metres by 1000 to get litres.
Cubic decimetre
Another name for the same volume as a litre. If a tank's dimensions are measured in decimetres, multiplying them gives litres directly.
Radius and diameter
The radius is half the diameter. Measure the barrel across at its widest point and divide the result by two.

Barrel and tank volume

Cylindrical barrel
Volume = π × radius² × height, where π ≈ 3.14. An illustrative barrel with a radius of 0.3 m and a height of 0.9 m: 3.14 × 0.3 × 0.3 × 0.9 ≈ 0.25 m³, or about 250 litres.
Rectangular tank
Volume = length × width × height. An illustrative 1 × 0.8 × 0.5 m tank holds 0.4 m³, or 400 litres.
Usable volume
A tap at the bottom and an overflow at the top reduce the volume you can actually use. Measure the height from the tap to the overflow, not the full height of the container.
Consistent units
Before multiplying, convert all dimensions to the same unit — metres or decimetres. Mixing centimetres and metres is the most common mistake.

Estimating rainwater collection

The basic rule
1 millimetre of rain on 1 square metre is 1 litre of water.
Estimating formula
Roof area on plan in square metres × rainfall in millimetres ≈ litres before losses. Illustratively: a 30 m² roof and 10 mm of rain give up to 300 litres.
Area on plan
Use the area the roof covers seen from above, not the area of the slopes: the pitch has almost no effect on the amount of water collected.
Losses
Splashing, evaporation, water held in gutters and the diverted first flush all reduce the yield. The formula gives an upper limit.

Properties of water

Expansion on freezing
When water turns to ice, its volume increases by about one tenth. That is why a full, closed tank or pipe can burst in a frost.
Ice is lighter than water
Ice floats and forms at the surface first. The crust traps the water beneath it, and the pressure on the walls grows as the freezing goes deeper.
Light and algae
Light helps algae grow. An opaque container and a tight lid reduce greening of the water.
Drinking water
Drink only water that is fit for drinking — from a checked source or bottled; do not drink rainwater or untreated water.

Where these conversions come in handy

  • Guides

    How much rainwater a roof can collect: area, rainfall and losses. The article catalogue is here too.

  • Questions

    Short answers on choosing a tank, collecting rainwater, watering, green water, mosquitoes and winterising.

  • Sections

    Seven sections: containers, rainwater, watering, summer shower, cleaning and green water, winterising, safety.

  • Collections

    Reading lists: your first barrel, roof water for the garden, a tank through winter without cracks.

  • Guides

    How much rainwater a roof can collect: area, rainfall and losses. The article catalogue is here too.

  • Collections

    Reading lists: your first barrel, roof water for the garden, a tank through winter without cracks.

  • Questions

    Short answers on choosing a tank, collecting rainwater, watering, green water, mosquitoes and winterising.

Sources

  • International System of Units (SI): unit definitions
  • Reference material on the physical properties of water (in general terms)
  • Editorial material of the guide

Information is current as of the date the page was prepared. Only unit conversions taken from their definitions and the general properties of water are exact here; tank sizes, roof areas and rainfall amounts in the examples are illustrative, so plug in your own measurements and do the sums yourself.